Metal shutter Cravent (78270)

Cravent (78270)

Your metal shutter expert in Cravent

DRM Paris is the metal shutter specialist in Cravent (78270) and across the Yvelines (78) department. Emergencies at any hour, made-to-measure installation, motorisation or simple servicing: the same method applies everywhere — free quote, public prices and guaranteed work, in Cravent as throughout Île-de-France.

Shopkeepers, homeowners, managing agents and businesses in Cravent: the quote is free, the amount is confirmed before any work and the invoice meets insurers' requirements. See the full price list on our metal shutter page, or call 07 66 54 96 41 directly.

24/7 emergency release
All-fault repair
Motor & motorisation
Shutter locks

Transparent prices

Metal shutter prices in Cravent (78270)

Service	Price
Metal shutter call-out (travel + diagnosis + minor repair)	From 150 €
Jammed shutter release	From 180 €
Shutter lock repair	From 200 €
Shutter axle repair	From 200 €
Electrical system servicing	From 200 €

See the full price list

Photos of our work

Our metal shutter work near Cravent

Repair of a shop shutter with tubes and transparent panels – repair in Cravent — Shop shutter repair

Metal shutter lock cylinder: replacement and freeing – repair in Cravent — Shutter lock and cylinder

Complete replacement of an extra-wide shutter's motorised shaft by our two technicians – repair in Cravent — Extra-wide shaft replacement

24/7 repair & call-out

Metal shutter repair in Cravent: every fault covered

Shutter stuck closed on opening day, curtain out of its guides, motor straining without lifting: our technicians diagnose the fault on site in Cravent and repair it to last, with common wear parts (slats, springs, locks, capacitors) on board.

Mechanical faults

Seized, warped or noisy winding shaft
Broken compensation spring, worn spring boxes
Jammed shutter lock or forced cylinder after a break-in
Curtain off its tracks or twisted side guides
Damaged guide rails after an impact
Bent, cracked or dislodged slats to replace

Electrical & motor faults

Dead remote control, blown fuse, power cut
Misadjusted limit switches: the shutter no longer stops
Shutter that only lifts halfway or moves in jerks
Faulty key switch or control box
Tubular or central motor failure
Failing safety edge or sensors

Shutters and grilles we service

Extensible grille and corrugated-tube curtain
Manual (push-up) or motorised metal shutter
Solid-slat metal shutter (galvanised steel or aluminium)
Straight-tube jeweller's grille, high security
Projection shutters and car-park closures
Micro-perforated slats for shop windows

We repair, replace and motorise every brand of shutter motor: Somfy, Simu, Nice, Becker, Came, Gaposa and generic drives. We also offer preventive maintenance in Cravent — greasing the guides, adjusting limit switches, checking the springs — to extend the life of your installation.

Frequently asked questions – metal shutter Cravent

Do you work nights and weekends in Cravent?

Yes: metal shutter repair in Cravent runs 24/7, public holidays included, on 07 66 54 96 41. A regulated surcharge applies at night and on Sundays; it is clearly announced on the phone before the technician travels.

Can you replace just a few slats in Cravent?

Yes. When the curtain is in good overall condition, we replace bent or cracked slats individually — solid, micro-perforated or grille — without changing the whole shutter. It is the most economical repair after an impact or attempted break-in.

Do you service metal shutters in Cravent?

Yes, we offer preventive servicing and maintenance contracts for businesses in Cravent: greasing the guides and shaft, checking the compensation springs, adjusting the limit switches and testing the lock. A well-serviced shutter rarely breaks down.