Metal shutter Orly (94310)

Orly (94310)

Your metal shutter expert in Orly

DRM Paris is the metal shutter specialist in Orly (94310) and across the Val-de-Marne (94) department. Emergencies at any hour, made-to-measure installation, motorisation or simple servicing: the same method applies everywhere — free quote, public prices and guaranteed work, in Orly as throughout Île-de-France.

Shopkeepers, homeowners, managing agents and businesses in Orly: the quote is free, the amount is confirmed before any work and the invoice meets insurers' requirements. See the full price list on our metal shutter page, or call 07 66 54 96 41 directly.

24/7 emergency release
All-fault repair
Motor & motorisation
Shutter locks

Transparent prices

Metal shutter prices in Orly (94310)

Service	Price
Metal shutter call-out (travel + diagnosis + minor repair)	From 150 €
Jammed shutter release	From 180 €
Shutter lock repair	From 200 €
Shutter axle repair	From 200 €
Electrical system servicing	From 200 €

See the full price list

Photos of our work

Our metal shutter work near Orly

Complete replacement of an extra-wide shutter's motorised shaft by our two technicians – repair in Orly — Extra-wide shaft replacement

Extra-wide metal shutter assembled and tested before fitting – repair in Orly — Made-to-measure extra-wide

Replacement of a shop's transparent-slat shutter in a shopping centre – repair in Orly — Shopping-centre replacement

24/7 repair & call-out

Metal shutter repair in Orly: every fault covered

Mechanical or electrical, a metal shutter fault in Orly is fixed in a single visit in the vast majority of cases. We handle emergency release after a break-in as well as progressive wear: slack springs, warped slats, an ageing motor.

Mechanical faults

Curtain off its tracks or twisted side guides
Jammed shutter lock or forced cylinder after a break-in
Bent, cracked or dislodged slats to replace
Broken compensation spring, worn spring boxes
Damaged guide rails after an impact
Seized, warped or noisy winding shaft

Electrical & motor faults

Shutter that only lifts halfway or moves in jerks
Tubular or central motor failure
Dead remote control, blown fuse, power cut
Misadjusted limit switches: the shutter no longer stops
Failing safety edge or sensors
Faulty key switch or control box

Shutters and grilles we service

Solid-slat metal shutter (galvanised steel or aluminium)
Projection shutters and car-park closures
Extensible grille and corrugated-tube curtain
Micro-perforated slats for shop windows
Manual (push-up) or motorised metal shutter
Straight-tube jeweller's grille, high security

Somfy, Simu, Nice, Becker, Came or Gaposa motor: our technicians carry the parts and programming tools for all common drives. Consider preventive servicing of your metal shutter in Orly: yearly greasing and adjustment prevent most jams and motor failures.

Frequently asked questions – metal shutter Orly

Do you work nights and weekends in Orly?

Yes: metal shutter repair in Orly runs 24/7, public holidays included, on 07 66 54 96 41. A regulated surcharge applies at night and on Sundays; it is clearly announced on the phone before the technician travels.

Can you replace just a few slats in Orly?

Yes. When the curtain is in good overall condition, we replace bent or cracked slats individually — solid, micro-perforated or grille — without changing the whole shutter. It is the most economical repair after an impact or attempted break-in.

Do you service metal shutters in Orly?

Yes, we offer preventive servicing and maintenance contracts for businesses in Orly: greasing the guides and shaft, checking the compensation springs, adjusting the limit switches and testing the lock. A well-serviced shutter rarely breaks down.