Metal shutter Margency (95580)

Margency (95580)

Your metal shutter expert in Margency

DRM Paris is the metal shutter specialist in Margency (95580) and across the Val-d'Oise (95) department. Emergencies at any hour, made-to-measure installation, motorisation or simple servicing: the same method applies everywhere — free quote, public prices and guaranteed work, in Margency as throughout Île-de-France.

Whether you have an emergency or are planning a project in Margency, honest advice over the phone costs nothing: call 07 66 54 96 41. Our prices are public and identical across the Val-d'Oise (95) department — no surcharge by town.

24/7 emergency release
All-fault repair
Motor & motorisation
Shutter locks

Transparent prices

Metal shutter prices in Margency (95580)

Service	Price
Metal shutter call-out (travel + diagnosis + minor repair)	From 150 €
Jammed shutter release	From 180 €
Shutter lock repair	From 200 €
Shutter axle repair	From 200 €
Electrical system servicing	From 200 €

See the full price list

Photos of our work

Our metal shutter work near Margency

Assembly of an extra-wide metal shutter by our technicians in the workshop – repair in Margency — Workshop assembly

Central shutter motor repair: crown and gears on the winding shaft – repair in Margency — Central motor repair

Micro-perforated slat shutter installed for a restaurant – repair in Margency — Micro-perforated slats

24/7 repair & call-out

Metal shutter failure in Margency: what we repair

Mechanical or electrical, a metal shutter fault in Margency is fixed in a single visit in the vast majority of cases. We handle emergency release after a break-in as well as progressive wear: slack springs, warped slats, an ageing motor.

Mechanical faults

Broken compensation spring, worn spring boxes
Bent, cracked or dislodged slats to replace
Curtain off its tracks or twisted side guides
Damaged guide rails after an impact
Seized, warped or noisy winding shaft
Jammed shutter lock or forced cylinder after a break-in

Electrical & motor faults

Dead remote control, blown fuse, power cut
Shutter that only lifts halfway or moves in jerks
Misadjusted limit switches: the shutter no longer stops
Tubular or central motor failure
Faulty key switch or control box
Failing safety edge or sensors

Shutters and grilles we service

Manual (push-up) or motorised metal shutter
Extensible grille and corrugated-tube curtain
Straight-tube jeweller's grille, high security
Micro-perforated slats for shop windows
Projection shutters and car-park closures
Solid-slat metal shutter (galvanised steel or aluminium)

We repair, replace and motorise every brand of shutter motor: Somfy, Simu, Nice, Becker, Came, Gaposa and generic drives. We also offer preventive maintenance in Margency — greasing the guides, adjusting limit switches, checking the springs — to extend the life of your installation.

Frequently asked questions – metal shutter Margency

Do you work nights and weekends in Margency?

Yes: metal shutter repair in Margency runs 24/7, public holidays included, on 07 66 54 96 41. A regulated surcharge applies at night and on Sundays; it is clearly announced on the phone before the technician travels.

Can you replace just a few slats in Margency?

Yes. When the curtain is in good overall condition, we replace bent or cracked slats individually — solid, micro-perforated or grille — without changing the whole shutter. It is the most economical repair after an impact or attempted break-in.

Do you service metal shutters in Margency?

Yes, we offer preventive servicing and maintenance contracts for businesses in Margency: greasing the guides and shaft, checking the compensation springs, adjusting the limit switches and testing the lock. A well-serviced shutter rarely breaks down.