Metal shutter Melun (77000)

Melun (77000)

Your metal shutter expert in Melun

In Melun (Seine-et-Marne (77)), a jammed shutter or a breakdown rarely fixes itself — and every hour counts. Our metal shutter specialists work day and night in your area: precise diagnosis, price announced before travel, lasting repair. Most faults are solved in a single visit.

Shopkeepers, homeowners, managing agents and businesses in Melun: the quote is free, the amount is confirmed before any work and the invoice meets insurers' requirements. See the full price list on our metal shutter page, or call 07 66 54 96 41 directly.

24/7 emergency release
All-fault repair
Motor & motorisation
Shutter locks

Transparent prices

Metal shutter prices in Melun (77000)

Service	Price
Metal shutter call-out (travel + diagnosis + minor repair)	From 150 €
Jammed shutter release	From 180 €
Shutter lock repair	From 200 €
Shutter axle repair	From 200 €
Electrical system servicing	From 200 €

See the full price list

Photos of our work

Our metal shutter work near Melun

Extra-wide metal shutter assembled and tested before fitting – repair in Melun — Made-to-measure extra-wide

Complete replacement of an extra-wide shutter's motorised shaft by our two technicians – repair in Melun — Extra-wide shaft replacement

Extensible grille protecting a delicatessen shop front after our work – repair in Melun — Scissor grille fitted and adjusted

24/7 repair & call-out

Metal shutter repair in Melun: every fault covered

Shutter stuck closed on opening day, curtain out of its guides, motor straining without lifting: our technicians diagnose the fault on site in Melun and repair it to last, with common wear parts (slats, springs, locks, capacitors) on board.

Mechanical faults

Seized, warped or noisy winding shaft
Damaged guide rails after an impact
Curtain off its tracks or twisted side guides
Broken compensation spring, worn spring boxes
Jammed shutter lock or forced cylinder after a break-in
Bent, cracked or dislodged slats to replace

Electrical & motor faults

Failing safety edge or sensors
Faulty key switch or control box
Shutter that only lifts halfway or moves in jerks
Misadjusted limit switches: the shutter no longer stops
Dead remote control, blown fuse, power cut
Tubular or central motor failure

Shutters and grilles we service

Manual (push-up) or motorised metal shutter
Micro-perforated slats for shop windows
Solid-slat metal shutter (galvanised steel or aluminium)
Extensible grille and corrugated-tube curtain
Straight-tube jeweller's grille, high security
Projection shutters and car-park closures

We repair, replace and motorise every brand of shutter motor: Somfy, Simu, Nice, Becker, Came, Gaposa and generic drives. We also offer preventive maintenance in Melun — greasing the guides, adjusting limit switches, checking the springs — to extend the life of your installation.

Frequently asked questions – metal shutter Melun

Do you work nights and weekends in Melun?

Yes: metal shutter repair in Melun runs 24/7, public holidays included, on 07 66 54 96 41. A regulated surcharge applies at night and on Sundays; it is clearly announced on the phone before the technician travels.

Can you replace just a few slats in Melun?

Yes. When the curtain is in good overall condition, we replace bent or cracked slats individually — solid, micro-perforated or grille — without changing the whole shutter. It is the most economical repair after an impact or attempted break-in.

Do you service metal shutters in Melun?

Yes, we offer preventive servicing and maintenance contracts for businesses in Melun: greasing the guides and shaft, checking the compensation springs, adjusting the limit switches and testing the lock. A well-serviced shutter rarely breaks down.