Metal shutter Draveil (91210)

Draveil (91210)

Your metal shutter expert in Draveil

DRM Paris is the metal shutter specialist in Draveil (91210) and across the Essonne (91) department. Emergencies at any hour, made-to-measure installation, motorisation or simple servicing: the same method applies everywhere — free quote, public prices and guaranteed work, in Draveil as throughout Île-de-France.

Shopkeepers, homeowners, managing agents and businesses in Draveil: the quote is free, the amount is confirmed before any work and the invoice meets insurers' requirements. See the full price list on our metal shutter page, or call 07 66 54 96 41 directly.

24/7 emergency release
All-fault repair
Motor & motorisation
Shutter locks

Transparent prices

Metal shutter prices in Draveil (91210)

Service	Price
Metal shutter call-out (travel + diagnosis + minor repair)	From 150 €
Jammed shutter release	From 180 €
Shutter lock repair	From 200 €
Shutter axle repair	From 200 €
Electrical system servicing	From 200 €

See the full price list

Photos of our work

Our metal shutter work near Draveil

Motorised shutter shafts assembled in our workshop, ready to fit – repair in Draveil — Motorised shafts ready to fit

Replacement of a shop's transparent-slat shutter in a shopping centre – repair in Draveil — Shopping-centre replacement

Installation of a galvanised solid-slat metal shutter on a shop front – repair in Draveil — Shop-front installation

24/7 repair & call-out

Metal shutter repair in Draveil: every fault covered

In Draveil, most metal shutter call-outs involve the same components: the curtain and its slats, the winding shaft and springs, the lock and the motor. Our technician identifies the exact cause — not just the symptom — before any repair.

Mechanical faults

Jammed shutter lock or forced cylinder after a break-in
Broken compensation spring, worn spring boxes
Seized, warped or noisy winding shaft
Bent, cracked or dislodged slats to replace
Curtain off its tracks or twisted side guides
Damaged guide rails after an impact

Electrical & motor faults

Tubular or central motor failure
Failing safety edge or sensors
Dead remote control, blown fuse, power cut
Faulty key switch or control box
Shutter that only lifts halfway or moves in jerks
Misadjusted limit switches: the shutter no longer stops

Shutters and grilles we service

Manual (push-up) or motorised metal shutter
Straight-tube jeweller's grille, high security
Micro-perforated slats for shop windows
Extensible grille and corrugated-tube curtain
Solid-slat metal shutter (galvanised steel or aluminium)
Projection shutters and car-park closures

We repair, replace and motorise every brand of shutter motor: Somfy, Simu, Nice, Becker, Came, Gaposa and generic drives. We also offer preventive maintenance in Draveil — greasing the guides, adjusting limit switches, checking the springs — to extend the life of your installation.

Frequently asked questions – metal shutter Draveil

How fast can you reach Draveil?

We answer 24/7 on 07 66 54 96 41. For a jammed metal shutter in Draveil, a local technician is typically on site within 30 minutes to 1 hour depending on traffic. Securing your shop or premises always comes first.

Metal shutter stuck in Draveil: what should I do while waiting?

Never force a jammed shutter: you risk bending slats, warping the shaft or burning out the motor, making the repair more expensive. Cut power to the motor, leave the lock alone and call us — we'll give you the right steps until the technician arrives.

How much does a metal shutter repair cost in Draveil (91210)?

Repairs start at €150 and emergency release at €180, travel and diagnosis included. The exact price is announced over the phone and confirmed by a free quote before any work — our rates are identical across Île-de-France, with no surcharge for Draveil.